SAM-R - KAC FSGB Gen 1 - KAC SR16 FF RAS 99167 - L Listing ID: 2986616

I am selling a personal build of mine that took me a long time to put together. It is 1/1 clone (other than lower receiver markings which were FN M16-A2 & full auto) of the USMC Squad Advanced Marksman Rifle. This was used in the GWOT as a designated marksman rifle. According to online sources 100 of these rifles were made for the Marines before it was discontinued from service in the mid 2010's. It is one of the more popular builds from the GWOT. A few of the parts for this clone are pretty un-obtanium - being the KAC FF long 99167 SR16 marked hand guard, KAC Gen 1 FSGB, Leupold TS-30 A2 3-9 scope & Krieger “PWS-P”marked 1:7 twist 20” SS heavy barrel. The lower is definitely the hard part of this clone because FN M16-A2’s were never (or very few) available to civilians. So instead I used a Colt “AR15-A4” non ambi lower. I added a new KAC 2 stage trigger, KAC ambi mag release, Colt ambi safety, Colt A2 stock kit and Magpul grip. It has never been fired. The build components and their values are below:

Colt raised “C AF” upper - ($350)
Colt AR15-A4 lower receiver with an A2 stock set ($750)
KAC 2 Stage trigger # 25926 ($300)
Colt ambi safety ($100)
Gen 1 KAC 600m rear big knob sight ($200)
Colt full auto bolt carrier “C Marked” ($150)
Colt bolt and hardware “MPD marked” ($150)
PRI gas buster charging handle with military latch ($100)
Arms # 22 lever 30mm high scope mount ($150)
Arms # 22 Scope ring rail ($250)
Leupold TS-30 A2 3-9 36mm scope with 30mm tube (Not available but maybe $1.5K )
KAC Vero Beach free float long hand guard # 99167 (only one available is $3K)
NT4 Muzzle device # 93048 ($150)
Krieger SS 20" “PWS-P” marked heavy barrel 1:7 twist (very few gunsmiths can turn this barrel and make those markings) ($500$
Harris Bipod w rail stud ($150)
KAC rail panels x 3 ($30)
KAC Broomstick ($50)
KAC ambi mag release ($100 - I can put the Colt non ambi back on if buyer prefers)
KAC swivel sling mount # 98720 ($50)
KAC Gen 1 FSGB ($2,500 if you can find them)
New form 3 NT4 Suppressor # 96062 ($1,500 - CANBE REMOVED FOR A $1,500 discount)
Professional assembly from a high level gunsmith ($500)
Total roughly around $12,500 + the years sourcing all of the parts and then waiting to have it out together!